How to program the FS 2.4G 6ch USB Programmable RC System for the helicopters used the TX/RX

 

Connect an USB cable from the transmitter to a computer,then turn on the transmitter:

Open the CD on the computer

 

 

Open the directory 'PL-2303 Deiver Installer'

 

Run the file:

 

Run the 't6config'

 

There is a new post 'T6comfig' on the desktop of the computer. Turn on the power of the helicopter. make sure the burshless motor 3 ports is already disconnecting on the helicopter:

 

Open the computer manager and equipment manager to check the new port 'Prolific USB-to-Serial Comm Port (COM9)',and remember the (COM9):

Run the 'T6config' and A menu is appeared:

Click the button 'Setting':

Select ‘COM9' you remember on the step 9:

Move 2 sticks on the transmitter, and block channels follow moving:

Click a button 'Stick Select',select 'MODEL1':

If your transmitter is mode 2 (mode 1 is right hand throttle, mode 2 is left hand throttle), you can select the 'MODEL2'.Other setting item are same with mode 1:

Click a button 'Type', select 'HELI-120',that is CCPM mode:

Click a button 'Reverse', select 'CH4',make the CH4-RUDDER of the transmitter is reversed:

Click a button 'Swash AFR', make sure they are same as follows

Click a button 'Pitch Curve' to setup 'EP0 %' for a low pitch of the blade on the helicopter

Change the 'EP0 %' until the low pitch is -2 degree (or 0- -3 degree) during the throttle stick of the transmitter put down bottom (mode 1 is right hand throttle, mode 2 is left hand throttle):

Setup 'EP4 %' for a high pitch of the blade on the helicopter

Setup 'EP4 %' for a high pitch of the blade on the helicopter

Change the 'EP4 %' until the high pitch is +10 degree (or 8-11 degree) by a pitch meter during the throttle stick of the transmitter put up top, if the EP4=100% still less than 10 degree, need to change the pitch range by the step 18,to change the CH6=-50 to -60 or more